LabSim Category

Policy Based Routing Sim

February 8th, 2019 digitaltut 257 comments

Question

Company TUT has two links to the Internet. The company policy requires that web traffic must be forwarded only to Frame Relay link if available and other traffic can go through any links. No static or default routing is allowed.

BGP_Policy_Based_Routing_Sim.jpg

 

Answer and Explanation:

Read more…

EIGRP OSPF Redistribution Sim

January 8th, 2019 digitaltut 284 comments

Question

OSPF_EIGRP_Redistribution.jpg

Answer and Explanation:

Read more…

OSPF Sim

January 8th, 2019 digitaltut 219 comments

Question

OSPF is configured on routers Amani and Lynaic. Amani’s S0/0 interface and Lynaic’s S0/1 interface are in Area 0. Lynaic’s Loopback0 interface is in Area 2.

OSPFSim

Your task is to configure the following:

Portland’s S0/0 interface in Area 1
Amani’s S0/1 interface in Area 1
Use the appropriate mask such that ONLY Portland’s S0/0 and Amnani’s S0/1 could be in Area 1.
Area 1 should not receive any external or inter-area routes (except the default route).

Answer and Explanation:

Read more…

IPv6 OSPF Virtual Link Sim

May 8th, 2018 digitaltut 153 comments

Question

TUT is a small company that has an existing enterprise network that is running IPv6 OSPFv3. However, R4’s loopback address (FEC0:4:4) cannot be seen in R1. Identify and fix this fault, do not change the current area assignments. Your task is complete when R4’s loopback address (FEC0:4:4) can be seen in the routing table of R1.

OSPFv3_IPv6_VirtualLink

Special Note: To gain the maximum number of points you must remove all incorrect or unneeded configuration statements related to this issue.

Answer and Explanation:

Read more…

EIGRP Stub Sim

May 8th, 2018 digitaltut 150 comments

Question

TUT Corporation has just extended their business. R3 is the new router from which they can reach all Corporate subnets. In order to raise network stableness and lower the memory usage and broadband utilization to R3, TUT Corporation makes use of route summarization together with the EIGRP Stub Routing feature. Another network engineer is responsible for this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been missing.

EIGRPStubSim

Presently TUT has configured EIGRP on all routers in the network R2, R3, and R4. Your duty is to find and solve the connectivity failure problem with the remote office router R3. You should then configure route summarization only to the distant office router R3 to complete the task after the problem has been solved.

The success of pings from R4 to the R3 LAN interface proves that the fault has been corrected and the R3 IP routing table only contains two 10.0.0.0 subnets.

Answer and Explanation:

Read more…

Practice Real ROUTE Labs with GNS3

May 8th, 2017 digitaltut 281 comments

Well, the title said it all. Here are some screenshots of the labs in GNS3:

+ OSPF Sim:

OSPF_Sim.jpg

Read more…