You have been asked to evaluate an OSPF network and to answer questions a customer has about its operation. Note: You are not allowed to use the show running-config command.
Question
Company TUT has two links to the Internet. The company policy requires that web traffic must be forwarded only to Frame Relay link if available and other traffic can go through any links. No static or default routing is allowed.
Answer and Explanation:
Question
OSPF is configured on routers Amani and Lynaic. Amani’s S0/0 interface and Lynaic’s S0/1 interface are in Area 0. Lynaic’s Loopback0 interface is in Area 2.
Your task is to configure the following:
Portland’s S0/0 interface in Area 1
Amani’s S0/1 interface in Area 1
Use the appropriate mask such that ONLY Portland’s S0/0 and Amnani’s S0/1 could be in Area 1.
Area 1 should not receive any external or inter-area routes (except the default route).
Answer and Explanation:
Question
TUT is a small company that has an existing enterprise network that is running IPv6 OSPFv3. However, R4’s loopback address (FEC0:4:4) cannot be seen in R1. Identify and fix this fault, do not change the current area assignments. Your task is complete when R4’s loopback address (FEC0:4:4) can be seen in the routing table of R1.
Special Note: To gain the maximum number of points you must remove all incorrect or unneeded configuration statements related to this issue.
Answer and Explanation:
Question
TUT Corporation has just extended their business. R3 is the new router from which they can reach all Corporate subnets. In order to raise network stableness and lower the memory usage and broadband utilization to R3, TUT Corporation makes use of route summarization together with the EIGRP Stub Routing feature. Another network engineer is responsible for this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been missing.
Presently TUT has configured EIGRP on all routers in the network R2, R3, and R4. Your duty is to find and solve the connectivity failure problem with the remote office router R3. You should then configure route summarization only to the distant office router R3 to complete the task after the problem has been solved.
The success of pings from R4 to the R3 LAN interface proves that the fault has been corrected and the R3 IP routing table only contains two 10.0.0.0 subnets.
Answer and Explanation:
Here you will find answers to EIGRP Simlet question
Question
Refer to the exhibit. BigBids Incorporated is a worldwide auction provider. The network uses EIGRP as its routing protocol throughout the corporation. The network administrator does not understand the convergence of EIGRP. Using the output of the show ip eigrp topology all-links command, answer the administrator’s questions.
Become a member to read all the tutorials, labs on our site!
