Share your ROUTE v2.0 Experience

Please I have exam after 4 days, if possible can you send me new Qs to my email: {email not allowed}
much appreciated

Please what is DnD, i don’t understand that term?

Hi I passed today with 8xxxx

^^^^^^^^^^^^^^^^^^^^^^^^^^

Total of 53 questions:
DND:
Frame Relay Multipoint Setup
Frame Relay LMI
AAA – They changed the description but this is manageable, just focus on their function.
Lab Sim:
EIGRP simlet – show ip int brief is disable (need to use sh run to get the loopback IP)
– sh ip eigrp 1 topology (for getting the AD)
OSPF simlet – just review the lab sim
EIGRP stub – i didnt get the 2 subnets just 1 subnet. Try using 255.255.240.0, just trial and error (i’m so nervous and regret did not perform this).
MCQs:
60% (current dumps) : 40% (new questions)
* A lot of IPv6.
* EVN – Technology used by EVN (I dont remember the exact word and the answer).
A: 802.1q
B: VRF-lite
1- logging console 7 what this command do when you enable cef on this device?
I choose it active log on console
What configurations does PPPoE allow? (Choose two)
A. Client can be installed on the same network devices as server
B. 8 clients can be configured on 1 CPE
C. Clients can connect to multiple hosts over DMVPN
D. Client connecting over ATM PVC
E. Client installed on native IPv6 network
Correct Answer: BC
In which two ways can split horizon issues be overcome in a Frame Relay network environment?
(choose two.)
A. Configuring one physical serial interface with Frame Relay to various remote sites.
B. Configure a loopback interface with Frame Relay to various remote sites
C. Configuring multiple sub interfaces on a single physical interface to various remote sites.
D. Enabling split horizon.
E. Disabling split horizon

thanks you for every one

&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&

@THE-Mask congrats man! which dump did you study the most? should people just study everything in general or should focus on few things? Also, can you clarify if new questions are completely different old ones or partially rePhrased ones? Thank you for some much needed info, and congrats again!

Hi all,

I just got here after the material.
can anyone share if the “Composite Quizzes” and “New Updated Questions” are up to date?

@next_try congrats and thx for your contribute on this forum. just to make sure around 20 new question its for dump @jbalvin share or no? Thx

i know this is not related to these exams but is someone here doing or have done any CCNP Data center exams recently and have valid dumps for it please! i need to clear the exams within few weeks >.< would be awesome if someone an assist please

So ive seen in the comments alot of different answers so I will ask. What are the DnD and Sims/Labs for Route 300-101 currently?

How can you mitigate fragmentation issues between endpoints separated by a GRE tunnel?
A. PMTUD
B. TCP MSS
C. windowing
D. ICMP DF bit

I think its A.

“TCP MSS as described earlier takes care of fragmentation at the two endpoints of a TCP
connection, but it does not handle the case where there is a smaller MTU link in the middle
between these two endpoints. PMTUD was developed in order to avoid fragmentation in the path between the endpoints. It is used to dynamically determine the lowest MTU along the path from a packet’s source to its destination.”

https://www.cisco.com/c/en/us/support/docs/ip/generic-routing-encapsulation-gre/25885-pmtud-ipfrag.pdf

Hi can you please sen me dexter and chinese dumps. Thanks!! lakecycake@ gmail. C. O. M

Which scenario can asymmetric routing occur?
A. active/active firewall setup
B. single path in and out of the network.
C. active/standby firewall setup
D. redundant routers running VRRP

Hello guys,
can someone please provide the dumps and VCE or PDF you use to pass the exam.

thanks

Regards,

@THE-Mask
could you please share the dump or any materials you studied from?

@THE-Mask or anyone can please provide a good material to practice ( Dumps , VCE,PDF)

thanks in advance

Which scenario can asymmetric routing occur?
A. active/active firewall setup
B. single path in and out of the network.
C. active/standby firewall setup
D. redundant routers running VRRP

Ans: ACD
It should only have one option…I hate these tests…
https://www.digitaltut.com/share-your-route-v2-0-experience/comment-page-87#comment-1909849

Woops https://www.cisco.com/web/services/news/ts_newsletter/tech/chalktalk/archives/200903.html

Can anyone correct the wording of questions and answer them ?

Up/down interface… what is the log severity level?
A. level 3
B. level 4
C. level 5
D. level 0
Correct Answer: A ?? C
—————————————————————
Question about uRPF configuration (2 choices)
A. the first answer i dont remember but is really easy to figure out
B. configured at the interface level
C. configured at global configuration
D. other option
Answer: A, B ???
—————————————————————
Technology used with EVN
A. MPLS
B. BGP
C. VRF Lite
D. DMVPN
Answer: A ?
—————————————————————
Where to configure the DHCPv6 relay IP address for a VLAN
Do you have to enable DHCPv6 relay in the global configuration mode/VLAN interface ???
Do you have to configure something on the VLAN interface/global configuration???
Answer??
—————————————————————

EVN technology is based on …
– MP-BGP
-MPLS
– VRF-LITE
-DMVPN

Answer – VRF-LITE
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/evn/configuration/xe-3s/evn-xe-3s-book/evn-overview.pdf

Pass today 801 score. Were used dexter dumps. 10 new questions. 1 New dnd. No New Labs. In eigrp lab on picture with topology were mistake, in realy r1 r2 r3 connect with other interfaces.

@Oleg
Congrats

do you use chineses dump, Oleg? or other???

Looking for dumps for the route and tshoot exam (hootbigb @ yahoo . com) . –Thanks

@Oleg

Congrats man!
Will you post here the new questions?

Thx

Hello guys, passed the exam this morning 9xx score.

Had eigrp and ospf simlets and a simulation with eigrp also.

Questions from all materials except a few.

Good luck

@Mister Izzie
am sure you will gone have fascinating weekend
congratulation man

congrats man, re: simulation with eigrp, is that sim one of the ones featured here ?

@ Mister Izzie or someone can You confirm that this D&D which is new is correct

ip dhcp relay information option –>automatically add the circuit identifier suboption and the remote ID suboption
ip dhcp relay information check –>check that the relay agent information option in forwarded BOOTREPLY messages is valid
ip dhcp relay information policy–>Configures the reforwarding policy for a DHCP relay agent
ip dhcp relay information subscriber-id–>enable an ISP to add a unique identifier
ip dhcp relay information trusted-sources–>configures interfaces on a router as trusted sources
ip dhcp relay information–> configured in global configuration mode applies to all interfaces

or with different words
Thanks in advance

Are the Labs/Simlets current on the site??
OSPF Simlet?
https://www.digitaltut.com/route-ospf-sim
EIGRP Simlet?
https://www.digitaltut.com/route-eigrp-simlet
EIGRP Stub Sim
https://www.digitaltut.com/route-eigrp-stub-sim

I cant seem to find the OSPF simlet that ppl are talking about

Anyone that has taken the test recently, is is still :
OSPF Simlet
EIRGP Simlet
EIGRP Stub Sim ??

Hi everyone. I just passed my CCNA last month. Hoping I could find some study materials links here for CCNP route. Thank you in advance

hello.can anybody send me 300-101 dumps ? my email is artur . mrdoyan gmail com

@gangia just took the exam yesterday, eigrp stub is still valid… but for some reason, i was not able to save the configurations.

please send to me dump. i have exam in tomorow :(

@ Mister Izzie or someone can You confirm that this D&D which is new is correct

ip dhcp relay information option –>automatically add the circuit identifier suboption and the remote ID suboption
ip dhcp relay information check –>check that the relay agent information option in forwarded BOOTREPLY messages is valid
ip dhcp relay information policy–>Configures the reforwarding policy for a DHCP relay agent
ip dhcp relay information subscriber-id–>enable an ISP to add a unique identifier
ip dhcp relay information trusted-sources–>configures interfaces on a router as trusted sources
ip dhcp relay information–> configured in global configuration mode applies to all interfaces

hello i want to get exam tomorrow are their new questions?

@zep, do save wasn’t working ? not even copy runnin start?
I’ve heard people complaining on not being able to save. hmmm did you pass? thanks in advance

what is the right answer?A?B?

Which statement about stateless and stateful IPv6 autoconfiguration are true?

A. Both stateless and stateful autoconfiguration require additional setup
B. Stateless autoconfiguration requires no additional setup, whereas stateful autoconfiguration requires additional setup
C. Stateless autoconfiguration requires additional setup, whereas stateful autoconfiguration requires no additional setup
D. Both stateless and stateful autoconfiguration require no additional setup

Hi all,

Passed today 300-101 with 87x thanks to allah, only study Premume Digitaltut and this dump

https://mega.nz/#!Cyx2FYhZ!cL2o1NYbmOeN8ruFNZ4SR_w7rFIaylzmHurBPAQoaDA

and get 10 new questions but if you study well you will solve it and get new DND i dont saw it in any dump – may be you call it AAA but in dumps there is another DND about router – server – user i dont know what is AAA from those – thanks to all of you and will meet you soon in Switch

@Essoooo
which labd did you have?

eigrp sim, ospf sim and eigrp stup and to ensure passing study all labs in this site

OSPF Evaluation Simulator?

From ROUTE_Jan_2018 digitaltut pdf
Question 4
Valid range for BGP private ASNs?
A. 64512-65535
B. 1-64000
C. 64512-65534

Answer A (which is in pdf) is wrong. correct answer is C.

@ccnp1

yes

Essoooo
you remmber which DND you have?

i am sorry cant remember as they are 3 or 4

@Esoooo Congrats and wish u luck for next challenge. fyi esoooo, i’m done in switch :)

How many you get DnD? and for lab its same?
about new Dnd it like this?
-Router
logon information tacacs server
promt username and pass

-tacacs server
authen
authorize

-user
attempts access the router
access credential

need your clarify and so many thanks

@cnp18 thanks dear

no not this DND but the other one is about authentication and authorization contain (if authentcation – group tacasc+ – group radius) something lika this