Share your ROUTE v2.0 Experience

Hi all
if anyone interested to swap my Tshoot premium Account(valid to after 23-Feb) with Route premium Account , please contact me by below email.

tarifi.abdallah @ gmail com

I passed today with 888.
I passed today with 888. Don’t forget study MPQ. There are many new questions in MPQ that there are no in topic.
Any labs is here. Good luck!

Hi guyz there are lots of new questions (±10) study very hard about topics also.

@See See En Pee
Composite quizzes are on this site but you have to be a member to see them. There are 10 of them in one section of the site and 15 in another.

Copy link and paste in your browser

IS FAKE
IS FAKE
IS FAKE
IS FAKE
IS FAKE
IS FAKE

Be careful guys

Hi Guys,

Passed with 790 , just on the line.
Labs:

1. OSPF Sim – Areas changed apart from backbone, IP address changed.
2. Eigrp Evaluation Sim – exactly the same as here
3. IPv6 OSPF Virtual Link Sim – Same as here

D&D – Lots of them – IPv6 router security, ACL, uRPF mode, frame-relay component, mGRE, AAA & one related to SNMP not sure if it is there on this site (surely i messed it up), i do not have a premium account.

Around 6-7 new questions which i could not find in dumps.

Thank you digitaltut & all the best to the guys who are planning to take the exam.

See you in T-shoot next

I have passed the exam. All you need to do practice, practice, practice then use digitaltut for your final prep. All the questions and labs are from here. Good luck!

anyone here have taken SPROUTE exam? Can you tell me how many labs?

hi guys, i will take exam tomorrow. I couldnt see any D&D question on November dumps. Also there are 10 MCQ. How many of them is exist on exam?

Hey,

i have my exam tomorrow and I will surely fail.
Just found out that there are other sections like MPQ and and and….

SOOOooooOOooo I should just hang myselfe :)))

Bye

Good luck for tommorow`s test takers !

any explanation about this Q:
Consider this scenario. TCP traffic is blocked on port 547 between a DHCPv6 relay agent and a DHCPv6 server that is configured for prefix delegation. Which two outcomes will result when the relay agent is rebooted? (Choose two)
A. Routers will not obtain DHCPv6 prefixes.
B. DHCPv6 clients will be unreachable.
C. Hosts will not obtain DHCPv6 addresses.
D. The DHCPv6 relay agent will resume distributing addresses.
E. DHCPv6 address conflicts will occur on downstream clients.

why A & D.
thx

I failed today, 718 points, the material here is not up to date and is too much for an exam that only has 55 questions.

Sorry for you 300 101 :(( Did you have premium membership on digitaltut?

I have passed today 9xx/1000

there were 3 sims – maximum MCQ questions were asked.
Two labs were same what everyone is having — OSPFv3 virtual link and OSPF with diff. area and process id.
One SIM EIGRP evl .

In my case maximum questioned asked. :-)

All the best – Good Luck!

Hi,

I’ve passed my route today with 9vv/1000. I’m so thankful to everyone here who shared their tips. Also thanks to Digitaltut, premium account is really worth to pass the test.

Please review MPQ, NUQ part 5 and part 6. There are new some questions like

1. D&D – SNMP
2. Triangular diagram with 3 routers, connected with RIPv2. Need to choose the correct configuration with correct metric from R1 to R3.

Please review well the sims here and you’ll be okay.

Thank you guys.

Anyone has latest February dumps?

Can anyone confirm the labs in the Exam? Is it only selected from the following:

EIGRP Stub Simulator
EIGRP OSPF Redistribute Simulator
Policy Based Routing Simulator
IPv6 OSPF Virtual Link Simulator
OSPF Simulator
OSPF Evaluation Simulator
EIGRP Evaluation Simulator

Thanks in advance

hi can you send D&D AAA and new D&D thanks my dears

Hi, I passed with 8xx 2 days ago.
I agree with with Tree Top. There are about 10 news questions and some questions has been changed.

I am saved by get the labs right and some drag and drop.

@gador
See post from Tree Top. That is what everyone is get.
However, study all the lab, it is not hard.

Hey guys I just passed the exam at 9xx.

I recommend premium account to pass.
Most of the questions are from MCQ NUQ 5 and 6. Study all DnD as I had 6 of them all from this site.

Below questions are the ones that I never have encountered.
There’s a question about BGP configuration needed for DSW1/Core belonging to a certain PEER 1. Exhibit just shows about authentication failure(invalid md5 hash).

Another is a group of 3 routers running RIPv2, what do you need to do to force the route of traffic to R3 then to the target network. Choices are something like applying offset to the metrics of interfaces.

Labs:
OSPF SIM – same here, just different IP and Area so be careful when configuring.
IPV6 OSPF Virtual link – same here
EIGRP Eval – same here

I have premium account valid til after Feb 23 for just $10, shoot me an email at vhin088 at gmail dot com if you are interested.
Good luck to you guys who will take the exam. Be confident if you mastered the contents of this site.

Thanks DigitalTut. Moving on to tshoot.

Additional tip for the sim, if you’re trying for example “show ip eigrp topology”, this won’t work in the exam and it will display “incomplete command”. Just add the AS# and it will work. “show ip eigrp 1 topo”. Goodluck!!

Rip force a default route

#set static route to target
R2(config)# ip route 0.0.0.0 0.0.0.0 209.165.201.2

#configure Rip to distribute the default route
R2(config)# router rip
R2(config-router)# default-information originate

Hi Everyone.
How many mcq can I try in premium account in digitaltut?

There were many questions in mcq around 100+.

My VISA card doesnt work to buy the premium account and I dont have pay pal account. I want to buy premium account. Can anyone suggest me how to do that? Thank you

I’ve failed today.

SIMLET
EIGRP Evaluation Simulator
OSPF virtual-link
OSPF Sim

DnD
NAT Proccess
Step 1: The packet is routed to an NVI
Step 2: The packet is assigned a dynamic or static binding
Step 3: The IPV4 source address is translated to IPv6
Step 4: The translation information is used to create a session

NAT64
+ network-specific stateful NAT64 prefix: IPv6 prefix assigned by an organization
+ NAT64 : supports application layer gateway
+ NPTv6 : translates 2001:1::/64 to 2001:2::/64
+ well-known stateful NAT64 prefix: supports IPv6 prefix 64:FF9B::/96

One about frame relay and I dont remember.

MCP and New Update Questions 5 and 6 didn’t appears to me in exam.

Some questions about TACACS, RADIUS, PPPoE, NAt64, DHCP Option, DHCPv6, EIGRP Variance, OSPF States, IP SLA, FRAME RELAY (few questions). I had premium account, but even the labs wasn’t helpfull in the end.

@Designated

Could you please help me sharing the dumps please

I just passed 15 minutes ago, and I’ve got the following:
1- 10 D&D, all of them from here.
2- OSPF sim, IPv6 sim, OSPF virtual link.
3- EIGRP evalu.
4- Many old and new questions. They focused on EVN, DHCPv6, and PPPOE.
Note: some commands in labs, you need to add AS number after EIGRP.

IPv6 sim???

IPv6 sim is the same virtual-link???

Hi, where can I get MCQ NUQ 5 & 6? Are they materials from this site (with premium account) or..?
Thank you!

Yes, same virtual link.

wich the DND?

Help from those who took the exam again after failing pleasssse

Was the sims the same?
And the questions similar?

@Anonymous, i used the premium account 9tut.

Focous into labs and study this topics:

NTP, TACACS, RADIUS, PPPoE, NAt64, NPTv6, DHCP Options, DHCPv6, EIGRP Variance, OSPF States, IP SLA, FRAME RELAY, LSA OSPF, NAT, AAA, VRF, EVN, PMTUD, uRPF, Netflow, Syslog..

There alot of questions into 9tut, but in my exam not appeared at all.

The 300-101 have this topics.

Network Principles
Layer 2 Technologies
Layer 3 Technologies
VPN Technologies
Infrastructure Security
Infrastructure Services

If you search this topics + 300-101 in google, you’ll can able to find each topic form the exam. I recomend https://ciscoexam.online/CCNP/300-101/

Hello friends.
Please do not believe in false comments, I just gave my exam and passed 9XX with the premium account. Everything they need is here!

=== REPLACE WWW BY . to AND GET DUMPS === …Is a scam!

Copy and paste this every time you see it.

Guys, do u have any latest dumps?

Failed today with 7xx
Done silly mistakes and way too careless
Retake next thursday.

There is one D&D about SNMP manager, agent, MIB, inform, trap, anyone have the answer?
Appreciate.

If you have premium look in the NUQ5 or 6.

@C
inform = alert message that requires a read receipt
trap = alert message that is read without a generating a receipt
MIB = collection if ibjects in a virtual database
SNMP manager = system that monitors SNMP hosts
SNMP agent = software component that reports SNMP data

Passed.
LAB: OSPF Sim, EIGRP Evaluation Sim, IPv6 OSPF Virtual Link Sim (forget to remove R3 and R4 virtual link for area54)
D&D: MPP/CoPP, mGRE/IPSec, AAA (auth-proxy command etc), ICMP redirect, Frame-Relay (point2point and point-multipoint)

1. uRFP modes (strict, loose, vrf) – not sure why I chose broadcast isntead of VRF
2. Something weird with one of answers “local logging” and “syslog” but the question was like about to ask for local filters.
3. Question 2 for DHCP routing blocking
4. Link-local updates for OSPFv6 – LSA 8
5. Which three items can you track when you use two time stamps with IP SLAs? (Choose three) delay jitter packet loss
6. Which command enables NAT-PT on an IPv6 interface?
7. Which two functionalities are specific to stateless NAT64? (Choose two)
8. NTP new one was to verify if you understand how the NTP service works – communication between peer and server. client sends broadcast of creates VPN or use multicast. Question verified both communication ends server and client.
Somthing like that one:
Which two statements indicate a valid association mode for NTP synchronization? (Choose two)
9. 2x GRE and requirements for interface up/down and route to dest
10. Which two protocols can be affected by MPP? (Choose two)
11. Which option is invalid when configuring Unicast Reverse Path Forwarding?
12. RIPng Question. Cannot receive RIPng updates. Why? -> I get for RIPv2 different port
13. I had somehing with BGP redistribution but cannot recall (new one).

I did not score high because I get stressed. Remember stay calm and trust first choice. Otherwise you do stupid mistakes. Thank you all in collaboration and creation of webpage.
Everythig is here. Part5 Part6 and MFQ together with New Updated Questions (posted on 28th-Feb-2019).

Passed today 9xx. Do not beleive anyone who says tut is not valid. Almost all questions were from here.
LABs OSPF SIM, EIGRP EVALUATION, IPV6 VIRTUAL LINKS. Same labs, only may be ip addresses and areas etc. will be different. IPV6 Virtual links was same even addresing. Most of questions from NUQ5,6 and MPQ. D&D s also from here.
Just dont panic as I did ))) tut is enough to pass.
Good Luck to everyone! Thanks TUT!

Do you remember the D&D?

=== REPLACE WWW BY . to AND GET DUMPS === …Is a scam!

Copy and paste this every time you see it.

Hi everyone, I pass the last exam (tshoot) yestarday but until now I have not received the cisco email telling me that Im a CCNP. I took the first exam (switch) in march 24 2017. Will I receive the compleate cert? or I need to take the CCNP SW again?

Hey everyone,
can download sim’s for this site to practice in cisco packet trace ?
Tranks.