Share your ROUTE v2.0 Experience

@shusuka

If you read all of OCT dump. You can pass it.

where i can find OCT DUMP ???

I failed today 765%

I studied MPQ, NUQ5, NUQ6 and All lab sim’s…digitaltut valid but finally read on
:) MPQ,NUQ5,NUQ6 are not enough to pass exam… lots of ipv6 question,NAT64 question have..

@nick
good luck you bro on next attempt

whats labs you see ?

hello guys

please share information who had today exam ???

@arnold you can download Oct dump from this link.
https://www.digitaltut.com/route-questions-and-answers

@shisuka

tnx you

@daniel

labs easy…Virtual-link,OSPF stub, Eigrp Evauluate…
but i cannot write memory or copy run start config on the virtual link lab… i dont understood this situation… but ospf stub everything okay…. 5-6 new question have on exams…. | Octaber dumps valid… next week next attempts) @daniel when you take a exam ?

@Nick

I failed my first attempt as well. I didn’t miss it by much kinda like you.

I went through all the links on the right side of the website, including the MPQ,NUQ5,NUQ6. I will say my first attempt MPQ,NUQ5,NUQ6 would have been enough to pass, but the labs got me tripped up a little. My 2nd attempt i had less labs and mostly questions. Good luck on your second attempt.

Also make sure you guys are looking up the correct answers, there are several wrong answers on this site.

@Nick

My friend why do you think you got just 765 ?

Do you think you did not get marks on the lab that you could not svae the configurations or just wrong answers on the MCQs ?

Please advice …

I am concerned a bit cause a lot guys said about the WR or COPY RUN START issue.
My exam is next week and i want to believe that this is not gonna be a problem to lose points.
A lot of candidates have said that in IPv6 OSPF Virtual Link
<>
but in OSPF Simulator everything worked fine…..So i suppose @AHM that @Nick(sorry man) should lost points in wrong answers in MCQs

**** copy run start/copy running-config startup-config/wr does not work – so just ignore it (you marks won’t get deducted****

Why copy-run start, WR doesnt work some labs? when i try it says ” incomplate command or Ambigius “… Ospf sim copy run work… but IPV6 Virtual Link Lab it’s does’t work… Failure to make Copy_run has an impact Result ?

55 Q
D&D NAT64, AAA
Labs OSPF STUB, IPV6 Virtual Link, Eigrp Eval…
5-6 new IPV6,DMVPN question

@Nick

tnx for your detail answer

i have exam 30 octomber

#@Nick…no man it has no impact to the result ..cisco issue

Where does the EVN marks the traffic to separate different users?

A. On the edge interface, with VNET tag
B. On the edge, with 801.Q
C. On the trunk, with VNET tag
D. On the trunk, with 802.1Q

A or C?? Dump say C

Just failed my route exam it was my first attempt i think I messed up on ipv6 ospf configuration lab

@yerardux. I think C..check this url without the blanks and see the picture with EVN
https://www.cisco.com /c /en /us /products /collateral /ios-nx-os-software /layer-3-vpns-l3vpn /whitepaper_c11-638769.html

I just finished the exam and I have increased the number of questions, I have failed

@Anonymous
which Frame Relay LMI extension DnD you are referring to ?Can’t find it here

also do you know which one is the SNMP DnD ?Do you have a link ?

@CCNP what did you study?

Hello All ,

Can you please help by sharing links to the following :

-DHCPv6 Drag and Drop

-Frame relay LMI Drag and Drop

-SNMP drag and drop

? I would really appreciate the help

I also take my exam yesterday, i reviewed all question here still failed.

@JJ sorry to hear man….where did u lose points?

Hello,

DO you know where i can find 300-170 dumps?

Thanks

Hi all, passed yesterday with 87x
questions were about 50-60% from oct dump, 10-15 new questions, and most questions were reworded. D&D aaa, dhcpv6. Simlets: eigrp eval -> same on this site, ospf ipv6 virtual links -> same but different IPs, and ospf simlet (stub area) where you also have to actually configure ospf on the router. All you need is on this site (Premium), but try to understand concepts as the questions were similar, but not exactly the same.
Thanks digitaltut! now road to TSHOOT

good luck to all ;)

@Jeremy

can you save your ipv6 virtual-link config? WR or Copy-run start?

I cant save my config(Virtual-Link)…but, ospf stub sim i can save…. WHY?

feiled today

only two D&D, labs ar same

Labs OSPF STUB, IPV6 Virtual Link, Eigrp Eval…

on lab ipv6 virtual link cant saved, dont know why, maybe i lose points about this ?

couple of new question have exam pool

@john what did you study?

passed today, 90% of Q from this site, Study MPQ, NU6, NU5 AND THE OLD QUESTIONS ON THE SIDE TOO.

Also beware, there are several wrong answers in the dumps you need to do your research and study the concepts as well.

@anonymous which q do u mean?

Where does the EVN marks the traffic to separate different users?

A. On the edge interface, with VNET tag
B. On the edge, with 801.Q
C. On the trunk, with VNET tag
D. On the trunk, with 802.1Q

A or C?? Dump say C

Cisco say:

An edge interface is mapped to a specific VN and is the point in the network where the VNET tag is applied to incoming traffic from VN users. Traffic traversing from an EVN device to VN users is untagged. Midpoint EVN devices do not remove, add, or swap tags.

@yerardux…..the picture in the same page shows that vnet tag is marked in the trunk interface,right?

Hey guys. Just returned from the testing center. Passed by the skin of my teeth. FINALLY done with the NP…finally.

IPv6 OSPF Virtual Link, EIGRP Eval, and OSPF Sim. ( Managed to blank completely on OSPF sim, so no idea how I passed.)

Nothing special on DD, just same as on the site. Only had 4. Stateful/Stateless NAT64, Frame Relay Multipoint config, AAA features, Steps of Nat process.

What I did want to tell everyone was that I had 48 MCQs. At least 30 of them were from MPQ or even older questions on the side of this site. I’ve spent the last 3 months prepping for this test, so I’ve read through every question on this site multiple times. But in the last few days, I leaned heavily on NU5 and NU6 and as many MPQ as I could fit in time wise. BUT, it’s a good thing I was slow on my prep, or I might not have seen most of the other questions. They seem to be going back into the vault to keep people on their toes.

I think I saw one or two questions I hadn’t seen that were probably candidate questions, but they were all about things and concepts covered here.

There was one question I didn’t remember seeing. Could be a candidate or I might have missed it. It was something like the following.

What DHCP Option must be set to allow static routes assigned?
A. Option 13
B. Option 33
C. Option 66
D. Option 67

@Hector
Stateful/Stateless NAT64, ….. witch one?

What DHCP Option must be set to allow static routes assigned?
A. Option 13
B. Option 33
C. Option 66
D. Option 67
Answer : DHCP Option 33
This option specifies a list of static routes that the client should install in its routing cache

@Hector..well done my friend…u confuse me…
u had 30 q from OCT dump…and the others 18 were from where..
i lost u…please explain to us

@AHM..thanks man….this q is out of OCT dump….u have found it in any dump or u just google it.

**** If i understood correctly…the OCT dump is not 100% enough to pass..Please share your exam experience***

@Greek_guy

I saw this question here in this site , someone has said that he saw it in his exam,
I am just trying to help and answer this question.

I haven’t seen this q in oct or july dump….there are q in this site
Which they aren’t in the dunp?

@Greek_guy.

I was trying to say that the New Questions 5 and 6 and Most Popular questions sections are not enough. I read through all 445 pages multiple times. Not just those 3 sections. I was trying to convey that a good portion of my questions were not from those 3 sections of the dump. Keep reading past page 200 guys. it’s worth it.

I posted that question because I specifically searched the dump. DHCP appears 302 times if anyone is interested. The question about DHCP and Static routes is NOT there. There is a question about Relay Agent and TFTP server that are similar, but not that question. I just thought I’d share as that is the point of this site.

@AHM. Thanks for the answer. I was actually curious, as I don’t remember ever reading about that option.

Failed it 7XX drag and drops multipoint fr/exec/NHRP drag and drop
Some ospf/ipv6 ospf/ eigrp SIM
My second failure there was a few questions that were new dhcp suppress updates/eigrp redistribution questions hopefully next time I pass

@Hector

Ok my friend, now i understand what u mean, u confused me with your previous post….i am sure that this q isn’t in this dump cause i have already read it 6 times and now iam on the seventh….anyway thanks for the advise…from your experience Oct dump is enough to pass ? And one more …how many q u have except dump? ….thanks anyway

Hi All,

can anyone tell me where do find links for MPQ,NU5 and NU6? Also is july dump separate from October dump? if so, can anyone share the link please?

@Praj
Here is the link:

https://www.digitaltut.com/route-questions-and-answers

done exam today 8xx/1000 ~ 55 questions

DnD (AAA, ACL, Frame relay, GRE)

3 Labs
– OSPF Stub Sim (Hostname, Area, OSPF Process ID – changed)
– EIGRP Evaluation Sim
– IPv6 OSPF Virtual Link

good luck! ^_^

Thanks AHM.
Link which you have shared is showing Oct pdf..does it include MPQ,NU5 and NU6 as well? I mean this pdf is combination of all these 3?