Share your ROUTE v2.0 Experience

hello guys…what is eigpr evaluation lab?i cant find it at the 9tut’s lab….

@busman

Yes, there are repeat questions on each quizz just for pratice.

get ur cert in 5 days

Please send me the latest dumps are gujju_robinhood(at)tutanota(dot)com. Thanks very much.

I took my test on 1/22/2019 and passed with 8XX. Thank you Digitaltut. The questions and material are still valid. The labs are same. I got the labs: EIGRP STUB, EIGRP-OSPF redistribution, and OSPF Evaluation. I ran into a few problems with the EIGRP-OSPF redistribution and had to reload the routers multiple times in order to get the routes to distribute to the neighboring routers.

Some pointers:
Study questions from MPQ (digitaltut premium member) and the New Updates Question #5 (digitaltut premium member); understand why the answer is correct.
Study labs and practice the commands and troubleshoot commands

I’ll check for any response for the next few days. Good luck!!

Could someone please send me the latest dumps Thanks

Anyone who wrote 2day can please share the experience of ROUTE 300-101

hi all,

did the test recently and passed with 8xx. I found it really hard to be honest.
SIMS: EIGRP Stub, OSPF sim, redistribution.
All D&Ds were from digital tut list.

I got a ton of frame relay/PPPoE questions. i knew those were my weak points, but i’d hoped that I wouldnt get many questions about them! still managed to pass though.

out of all the questions i got at least 10 – 15 new questions that were not in digitaltut’s most popular or new questions part 5. digitaltut really helps in knowing what type of questions you’re going to get, but you really need to be learning the technologies and configs inside out in addition to reading the digitaltut dumps. ensure you know each of the SIMs before sitting the exam.

good luck to everyone on their CCNP Route.

what type of questions maybe they are in nnettworking 757 q ? I think that a lot is in there

pretty sure these were questions i hadnt seen anywhere else. can’t remember what they were, sorry.

hi i44r, have you studied 227q and 757q as well? Maybe the new questions you have mentioned were there?

Hi all,
Today I passed my 300-101 exam with 9**/1000.
Thanks for your sharing.

I had 53 questions and passing score was 790.

All questions came from 757q and 227q.

I had the following sims:
-OSPF eval sim
-EIGRP Stub lab sim
-EIGRP & OSPF Redistribution lab sim

I had the following D&D questions:
-Frame-relay (the one including ‘virtual-template1’)
-the one including NAT64 & application layer gateway
-Stateful & Stateless

Good luck to everyone!

Quaoar

can you please send me the files 757q and 227q to this email.?
or anyone who has them please send them.

{email not allowed}

Thank you.

Quaoar,

Can you please send me the files 757q and 227q? Much appreciated.

Or anyone else who has them, please send them. Much appreciated.

gujju_robinhood(at)tutanota(dot)com

you guys got the OSPF evalutaion in your exam ? or the OSPF simulation ?

@Olivia please send me the dumps you used here kelvincenka (at)gmail dot com
Any one else is free to share especially those who did the exam this year, mine is really soon. Kindly assist.
Thanks in advance.

Which adverse circumstance can the TTL feature prevent?
A. routing loops
B. DoS attacks
C. link saturation
D. CAM table overload

Hi what is the correct answer here (A or B)

@ CCNP Dream The correct Answer is: A

@ CCNP Dream

it is same as question 149 on Route_Dec_2018 pdf file

Answer: B

Explanation

This question mentions about the TTL Security Check for multihop BGP Peering Sessions.
The BGP Support for TTL Security Check feature provides an effective and easy-to-deploy
solution to protect eBGP peering sessions from CPU utilization-based attacks. When this
feature is enabled, a host cannot attack a BGP session if the host is not a member of the local
or remote BGP network or if the host is not directly connected to a network segment between
the local and remote BGP networks. This solution greatly reduces the effectiveness of DoS
attacks against a BGP autonomous system. An example of configuring this feature is shown
below:

Router(config)# router bgp 65000
Router(config-router)# neighbor 10.1.1.1 ttl-security hops 2

This sets the expected incoming TTL value for a directly connected eBGP peer. The hopcount argument is set to 2 configuring BGP to only accept IP packets with a TTL count in the
header that is equal to or greater than 253. If the 10.1.1.1 neighbor is more than 2 hops away,
the peering session will not be accepted.

Reference: https://www.cisco.com/c/en/us/td/docs/ios/12_2sx/feature/guide/fsxebtsh.pdf

@ TACACS+ thank you.

How about this
Which location within the network is preferred when using a dedicated router for Cisco IP SLA operations?
A. user edge
B. provider edge
C. access edge
D. distribution edge
In route dec. answer is “B” and in spoto “A”

@ vincent, thank you for the explanation. There is a lot of different answer between spoto and route_dec.

@ CCNP Dream Correct Answer is: A

@ CCNP Dream SORRY THE ANSWER IS: D

whats the answer guys ?

which technology supports overlapping ip addresses on a single interfaces ( 62/100 227q )

a-Qos
b-Vrf Lite
c-policy based routing
d-on-demand routing

b or c?

and this one as well

I am so confused with this question? Does anyone confirm what is the answer.

– which command can be entered on router R5 to configure 80 percent of bandwidth of a link EIGRP Autonomous System 55?

a- R5(config-if)#ip bandwith percent eigrp bandwidth 55 88
e- R5(config-if)#ipv6 bandwith-percent eigrp bandwidth 55 88

a or e? I didnt type in rest of them.

I think a is correct.

Both are wrong
instead it should be like this below

e- R5(config-if)#ipv6 bandwith-percent eigrp 55 80

@ networkc2020
the correct answer is: B

I have just got you the answer in GNS3

R1(config-if)#ipv6 bandwidth-percent eigrp 55 80

One advise guys for certains questions, you need anyone to tell you the right answer you can just TEST it yourself in GNS3 to be sure. At the end of the day CERTIFICATION will not get you a job SPECIALLY in NETWORKING. They need someone who can do the job, a problem solver.

Hi tacacs+, thanks for your answer. I have trıed on gns3 this commond
R1(config-if)#ipv6 bandwidth-percent eigrp 55 80
and i did not see it. Thats why i needed to ask.

I have checked one more time I have made a mistake while I have type in.
Regards.

hi tacacs+, thanks for your answer. I had already tried before I have asked. I had made a mistake last.

I had tried one more time that works.

Regards.

Which adverse circumstance can the TTL feature prevent?
A. routing loops
B. DoS attacks
C. link saturation
D. CAM table overload

Answer is A
Until the question has some additional information, the answer would be A because the main feature of TTL was to prevent routing loop.

Hi Guys

the link below is not valid for 9tut ccnp route questions:
https://www.mediafire.com/file/xhn6ran5hcqb971/ROUTE_Dec_2018.pdf

anyone has a valid link for ccnp route questions?

Thanks

what is the answer guys?

Which two statament about the latency is true?

a- high bandwith on a link
b- split horizon
c- propagation delay
d- serilization delay
e- under utilization of a link

@ networkc2020 The Answer is: C

TACACS+, i need two answer c and d right ?

@storm

please to send vce for dec_2018 to mine mail

ccn**p*1**2*go{@}g***m*a*il.**c*o**m

plese to remov * and {}

thnks in antisipetion

@digitaltut, December 2018 PDF is missed on mediafire.com, fix it please!

December 2018 PDF no longer present on MediaFire. Can someone reshare it?

Can any one share thoughts on SPOTO dumps trustworthiness?? Is it good to purchase and prepare for exam.

Thanks in advance.

The december 2018 file on mediafire is missing. Can anyone share please.

To configure 6to4 tunneling on a dual-stack edge router. Which three of the following are valid components in 6to4 Tunneling configuration? (Choose Three)
A. IPv4 Tunnel IP address
B. Tunnel mode (6to4)
C. Tunnel Keepalives
D. IPv4 Tunnel Destination
E. IPv4 Tunnel Source
F. 6to4 IPv6 address (within 2002::/16)
Correct Answer: BEF

isnt it BDF?

Hi everybody,

can you please advise, whether the OSPF evalutaion you got in the exam, is the one with 6 routers or the one with 3 routers (Portland etc..)?

Thanks a lot in advance.

Hi guys, i have passed the exam with the score 8xx. Most of questions is available in premium membership. I have studied 227q, MPQ’s in premium membership, and 757q (I cant say that I have studied that much for 757q, it will be good of you studied, just an advise.) thanks a lot for digitaltut families and go through switch exam.

I had eigrp stub, ospf sim, eigrp redistribution lab.

My advise is, check the question in dumps and MPQs is really true and make sense.

Best regards.

Hello everyone, I’ve just passed with a score of 8xx.

SIMs, IPv6 OSPF Virtual Link, EIGRP Evaluations, EIGRP Stub
D&D, Loose/Strict Mode, NAT Process, DMVPN

I studied the Route_Dec_18.pdf available on this site and also signed up for the premium account (which I highly recommend).
Most of the questions were from this site and the pdf mentioned but there were some I had not seen before (which I can’t remember now, sorry).
If you study all the pdf questions and learn the labs you should be fine to pass. The premium account was definitely worth the $15

Good luck everyone

Sorry, should also say a big thank you to everyone (except the scammers) who contribute and run this awesome site. So thanks!!!

Sometimes its difficult to know who to believe.. Are Cisco Randomizing exams now as Its been a few years since I last took an exam but by looking at the comments the LAB and DnDs seem to change on a daily basis (or maybe not) and I am only looking to re-certify..

(apologies if you are one of the below commentators and you are legit I’m just using the most recent examples)

bobafett January 28th, 2019
Hello everyone, I’ve just passed with a score of 8xx.

SIMs, IPv6 OSPF Virtual Link, EIGRP Evaluations, EIGRP Stub
D&D, Loose/Strict Mode, NAT Process, DMVPN

I studied the Route_Dec_18.pdf available on this site and also signed up for the premium account (which I highly recommend).
Most of the questions were from this site and the pdf mentioned but there were some I had not seen before (which I can’t remember now, sorry).
If you study all the pdf questions and learn the labs you should be fine to pass. The premium account was definitely worth the $15

Good luck everyone
———————————————————————————————————-
Emma January 27th, 2019
Hi guys , i passed the exam today 985/1000

– 3 Labs: EIGRP stub, PBR, EIGRP eval
– 6 DNDs: DHCP, adverse network conditions, AAA, Frame-relay component and LMO, TACACS+ACL
———————————————————————————————————–
mathematica January 23rd, 2019
Passed my exam today. Thanks digitaltut! Below some of the questions:

Labs:
OSPF sim – the one with portland switch only difference is area is 6 and ip is 192.168.20.5
EIGRP Stub Sim same as here
EIGRP Evaluation

Why are ppl putting questions from CCNP SWITCH? O_o

@ networkc2020,bobafett congraats and we apprciete the feedback
so basically Route_Dec_18.pdf is valid enough for passing and
any new Questions you uncounted on the exams if guys still
remember can you guys share.

I have an exams soon. And @QSA55 I have mailed you but your
email is invalid. Anyupdates to anyone who wrote today please share.

Thanks,
Storm

Can any one send the 757 q dumps to me
moatasem82 @ hotmail . com
Please
Please
Plase

Can any one send the 757 q dump to me
moatasem82 @ hotmail . com
Please
Please
Please