Share your ROUTE v2.0 Experience

@a7med, yes it is valid.

What ist he purpose of the autonomous-system{autonomous-system-number}command?

A.It sets the EIGRP autonomous system number in aVRF.
B.It sets the BGP autioimius system number in a VRF.
C.It sets the global EIGRP autioimius system number.
D.It sets the global BGP autioimius system number

a7med, Lebron James, can you plz share your dumps

@Largo
The syntax “distribute-list 1 GigabitEthernet0/0 out” is WRONG
Reference: http://www.ciscopress.com/articles/article.asp?p=2273507&seqNum=10

@Largo
The syntax “distribute-list 1 GigabitEthernet0/0 out” is WRONG
Reference: h*t*tp*:*//*www*.ciscopress.*com/*articles/article.asp?p=2273507&seqNum=10

Mohammed محمد

plz confirm and post you mail

@doka1

You are wrong Correct answer is distribute-list 1 GigabitEthernet0/0 out “F” because in description we have ONLY outgoing updates NOT incoming and outgoing, So based on Score 980 of some man early before he choose F NOT passive interface and HE WAS RIGHT BASED ON HIM SCORE so DONT BE SURE OF SOME LINK of cisco because this is tricky question just read careful description

@Someone17
Maybe is the question in the dump wrong?
Because the syntax “distribute-list 1 GigabitEthernet0/0 out” is definitivly not correct. Correct would be “distribute-list 1 out GigabitEthernet0/0”

OF JAZZYv3 my CORRECTION IS BELOW
——————————————————————————————————–
31 without D at the end we choose TCP MSS

40 D Because The router does not check if a user is logged into the console port or a device is attached to it; if console logging is enabled, messages are always sent to the console port that can cause CPU load.
http://blog.router-switch.com/2013/12/configure-logging-in-cisco-ios/

41 C Because we have technology NOT ENCAPSULATION so VRF Lite is the best choise
58 CF Because we have “limitation” not “USE” So what is NPTv6? NPTv6 is simply rewriting IPv6 prefixes. If your current IPv6 prefix is 2001:db8:cafe::/48 then using NPTv6 it would allow you to change it to 2001:db8:fea7::/48 – that is it.

It is a one for one prefix rewrite – you can’t overload it, have mismatching prefix allocations sizes, re-write ports or anything else. Importantly, it doesn’t touch anything other than the prefix. Your network/host portion remains intact with no changes.

http://www.howfunky.com/2012/02/ipv6-to-ipv6-network-prefix-translation.html

OF 477 corrected by Prince my CORRECTION OVER Prince is:
—————————————————————————————————–
154 D Time is the correct answer not Password because no where in EIGRP authentication Cisco don’t mention for Passwords they mention about KEY CHAIN and the Time must the same to be authenticated
203 A
216 CF I am not sure about this question
237 D Because this is descrip in Chapter 1 in Cert Guide This answer is 100% Correct
264 BE This is the correct Answer I am sure for this
376 ACD In DMVPN support EIGRP,BGP,OSPF and RIPv2 but RIP is more appropriate in SPOKE TO SPOKE TOPOLOGY NOT TO HUB TO SPOKE, on the other Hand OSPF create more CPU in DMVPN but is more acceptable then RIPv2 so Correct answer is ACD
431 CF same as Q58 on Jazzyv3 I already wrote Explination for this
439 C same as Q41 on Jazzyv3 I already wrote Explination for this
440 D same as Q40 on Jazzyv3 I already wrote Explination for this
459 F 100% sure is CORRECT because we have ONLY OUTGOING
——————————————————————————————————
So This is my Correction of the Corrected 477Q by Prince and Jazzyv3 2May

@doka1

Yea Just answer is little incorrect but in real exam I hope to be write correct But this is the correct anyway

@unstoppable
DMVPN and supported protocols.
Actually 4 are supported: EIGRP, OSPF, RIPv2, BGP.

you are fu@cking idiots, stop sharing fake links .
Arent there any boss will share valid dumps and we all write comment number if someone ask?
And no one will click mother fu@ cker ‘s link .

and please give answer my last quesiton

Please share answer for below questions.

01) Which two GRE features can you configure to prevent fragmentation?
A. TCP MSS
B. DF Bit Clear
C. IP MTU
D. PMTUD
E. MTU ignore
F. UDP windows sizes

02) The enterprise network WAN link has been receiving several denial of service attacks from both IPv4 and IPv6 sources. Which three elements can you use to identify an IPv6 packet via its header, in order to filter future attacks? (Choose three.)
A. Traffic Class
B. Source address
C. Flow Label
D. Hop Limit
E. Destination Address
F. Fragment Offset

03) If you convert a WAN connection with OSPF from T1 to a Frame Relay circuit, which two actions must you take to enable the connection? (Choose two)
A. Manually configure neighbors in the OSPF process.
B. Manually configure the hello and dead timers.
C. Change the OSPF network type to multipoint nonbroadcast.
D. Change the OSPF network type to broadcast.
E. Change the OSPF network type to nonbroadcast.

@Mohamed contact me plz

ahmedmadiboi @ yahoo dot com

hello guys;

is there questions about frame-relay

regards

Other than a working EIGRP configuration, which option must be the same on all routers for EIGRP authentication key rollover to work correctly?
A. SMTP
B. SNMP
C. Passwords
D. Time

Please answer. answer is C or D ?

Passed exam today with 9xx

Jazz477 and Jazz91Q are still valid.

*Question on show ip eigrp vrf purple topology. I don’t remember the answers.

*DND dhcp with few changes.

*q129 Which option prevents routing updates from being sent to the DHCP router, while still allowing routing update messages to flow to the Internet router and the distribution switches?
the passive interface options have been replaced by distribute-list.

*Question about syslog port 514.
1 more question, i couldn’t remember

The exam was easy.

Good luck to all

Passed exam today with 9xx.
9tut, Jazz477 and Jazz91Q are valids.
EIGRP STUB sim, OSPF and EIGRP Eval sim.

@PAL
how many question came from 91Q and any new questions apart from vrf purple?

Thanks.

@sieg
same questions to you mate :)

@bolo
3 new questions and 2 questions with few changes
sim: pbr, eigrp stub, eigrp eval
most of the questions from 91q.

hello
please the links of Jazz477 and Jazz91Q

I have just pass exam, the dump Jazz 477 and 91Q still vaild
EIGRP stub and EIGRP eval sim, PBR
just read 477 and a little 91Q is enough
Good luck !

just pass the exam Jazzy 477 , 91 and prince q91 version 1 are still valid. many question were from prince 91 , two new questions that I do not remember 5 d&d from Jazzy
Eigrp simlet, pbr and eigrp stub. I could not save my conf . the command copy run start was not work.
the exam is easy, don’t be affraid.
Thanks Prince and Jazzy who help enough with the files they posted here. Also thanks to this side.
Moving now to switch part.
Thanks again to all those people who helped.

Hi guys, I passes the exam with 8xx score.

I studied 91q Prince + DnD Jazzy, digitaltut and did a course in learning space mode.

4 or 5 new questions about bgp, vrf and snmp.

Hi guys – where can I find the 91q dump?

NF You can find between 111 – 120 pages

@josue
do you remember which dnd you had in your exam?

thx

MSA , these are D&D I had in my exam, I do not remember the the last one. I had 5of them and just remember 4

IPsec : protocol used to secure tunnels.
Keepalive : used to keep other side if tunnel interface up with local side is up
mGRE : Protocol to connect multiple destinations
MSS : amount of data that a device can handle as unfragmented piece
tunnel key : used to authenticate connection

DLCI : A locally significant ID
FECN : An indicator of congestion on the network
LMI : A signalling mechanism for Frame Relay devices
PVC : A logical connection comprising two endpoints and a CIR
SVC : A circuit that provides temporary on-demand connections between DTEs

1. DHCP Relay information
ip dhcp relay information option –> add suboption and the remote ID suboption
ip dhcp relay information check –> Verify relay information option (in forwarded BOOTREPLY)
ip dhcp relay information policy …… –> Define reforwarding rules (for a DHCP relay agent)
ip dhcp relay information subscriber-id –> enable a service provider to add a unique ID
ip dhcp relay information –> configured in global configuration mode applies to all interfaces

excessive unicast floading—–> condition aused by ….
out of order ——-> Potential result of diabling fifo
tcp starvation ——>potential effect of excessive udp traffic on the lik
asymetric routing ——>Cause of inconsistent traffic pattern
latency——–>condition in witch packets require and excessif length of time

Hope it can help

@josue

really appreciate for your useful information.

Hello guys,

I just passed the exam earlier today. Everything but a few questions were covered by Jazzy 477 , 91 and prince q91 version 1.

Labs: EIGRP sim, OSPF Sim and EIGRP Stub Sim. Go at it guys it is not that difficult if you have been doing your studies. Good luck and now to TSHOOT, my last exam!!!

Thank you Digital TUT! ;)

@josue, what did you do if the copy run start did not work?

The copy run start or wr did not work and I moved to the next question. At the end of the exam, I mentioned that at the space provided by Cisco for comment.

F u c k you people . I came back to f u c k you useless people Son of b!tches

Ghost, why so sad? Do you need a hug? Do you need a friend? Judging from the amount of time you spend here trolling, its a safe bet that you are “frustrated”. Sorry, do not let that deter you, you will find someone that you can be happy with. Not all girls are all that picky, go for personality not superficial things like looks and the girls won’t either.

Long story short Ghost, grow up.

Losers!

Hi Guys, I study Jazzy v3 and Jazzy 477. but they have difference answer.

In which scenario can asymmetric routing occur?
A. active/active firewall setup
B. single path in and out of the network.
C. active/standby firewall setup.
D. redundant routers running VRRP.
91Q Answer: D
Jazzy 477 answer: A

@sieg
Can you send me 91Q please bro?

mstf29.bsm at gmail dot com

@josue
bro please send us 91Q

Just passed with 963. 91Q helped a lot but few still came from 477Q. However, 2 new MC were found and 1 new Drop&Drag was about frame relay multipoint configuration steps. If i recalled it correctly, the four D&D blanks were:

A) Interface s0/1
B) encapsulation frame-relay
C) interface s0/1.101 point-multipoint
D) frame-relay map ip 10.0.0.1 101 broadcast

@PTA,

Can you tell us whats the new questions ? i am planning in coming week please guide

@DummyPass, its prince 477 or Jazzy?

@DummyPass congrats! Very High score

everyone can you send me dump 477q 91q ad 91 prince ? email {email not allowed}

thanks a lot

Hi Guys, I study Jazzy v3 and Jazzy 477. but they have difference answer.

In which scenario can asymmetric routing occur?
A. active/active firewall setup
B. single path in and out of the network.
C. active/standby firewall setup.
D. redundant routers running VRRP.
91Q Answer: D
Jazzy 477 answer: A

@Ghost
go and get some spooky nights next halloween!

read Prince 91v1 for MCQs
and
Jazzy 477q for DnDs/ Sims…

Have I got above correctly ?

@Lebron James
can you sen me dumps bro please ?
mstf29.bsm at gmail dot com

Routeontheway Jazzy has a dump that is v3 that was updated in may I believe. Has prince MCQ’s + DnDs. Please correct me if I am wrong.

Hi Guys,

I have passed the exam now. Do not worry that Exam is really simple. Study only jazzy dump v3.It is enough to pass.Only one lab I had which is eigrp stub receive only question.

Good Luck