Share your ENCOR Experience

Just got over the line.
Digitaltut dumps are enough to pass the exam. Just learn and understand them thoroughly.

@ Techaz i am taking mine tomorrow any new questions?

@Nick
Yes New Questions are obviously there but, out of those new questionsn many are modifications of the existing ones. So the point, prepare digitaltut file very well by understanding and you can pass easily with a good margin.

@Tecchaz, much appreciated.

@techaz
how different are the modification questions??

@techaz
how different are the modification questions??
also, are the questions in digitaltut exact same as the existing exam? (excluding new ones)

There is an exhibit that shows the show etherchannel summary output showing SW2 configured with PagP and SW3 configured with LACP.

Which action resolves the EtherChannel issue between SW2 and SW3?
A. Configure switchport mode trunk on SW2
B. Configure switchport nonegotiate on SW3
C. Configure channel-group 1 mode desirable on both interfaces
D. Configure channel-group 1 mode active on both interfaces

C or D?

Hi guys, passed today with 8xx score. Be careful, because many questions (40%) are not present in the premium zone. New questions are about Wireless, DNA, SD-WAN, access list, etherchannel, Routing, NAT and Virtualization and more topics.

Good luck!

still no updates?:(

Just passed exam with 9xx , where here are valid but there is still many new questions on python ,wireless rest conf.
Study here but understand all the concepts.

Hi,

New dump was posted on 31st, someone could confirm all questions are in this dump?
Thank you

where did you see last dumps on 31st. Last update is 28th. Took test today, lots of new question. Good luck.

Did the exam and passed. Do not rely only on Dump. Lot of questions from phython/JSON. Also new questions in all the areas like ACL, Wireless, SDWAN, Virtualization etc. dump helps ,but you will need a thorough knowledge about all the config , troubleshoot , theories in current exam situation. My advise if you only rely with dumps ATM do not waste your money…Sorry but this is the sad truth currently. Hope @digitaltut may have a solution for this soon.

@NN I passed today as well and I agree with you , I was stuck on many questions that are not here and needs deep knowledge.

@digitaltut, when will you update new questions?
Please you can answer

Hi,

Here is the dump : https://www.digitaltut.com/encor-questions-and-answers

Jay, new questions are not in this dump

@Jay,
Does the version3 (file with 169 pages) cover all the new questions from exam as well?

@Hey. Agree. I was stuck too in many questions. It was not easy going those 2 hours, more than 60% of questions they provided exhibit and asking the answers. Need lot of brain power 😉.

Where are the new questions please?

Anyone can provide a new question?

@Dweller

No, it doesn’t

@Past users of this site:
How long does it normally take for digitaltut to update the new questions and provide valid answers?

@NN
Congratulations on passing! Are you a premium member? Did you use the dumps available on premium membership before taking the exam?

What is Part 5 questions every body is referring too ?
In the latest dump 169 Pages I can only se New Question Part 2.. Am I missing something ?
Also what is the difference between premium if the dumps are simply updated here ?

@Dweller,

Yes. I am a premium member and studied all the questions more than 3 times ( around 371 ques). Simply i got the 100% for all last 3 attemp for composite quequestions before the exam. But as mentioned before lot of things have changed in questions /answers.

Agree with the last people that took the test yesterday. If you want to pass you will need deep knowledge and brain power. Test has changed a lot, questions in this site no valid anymore. Hopefully, digital update the site soon.

I just recently passed exam. Premium membership helped a lot although there are a number of new questions as well. But as long as you have understanding of the concepts you’ll be able to answer some of them.

Good luck to future takers.

It seems that there are sets of exam, some are minimal change, some are 40% changes.

So you are lucky if you get the exam set that have minimal change.

so it seems being a premium member at the moment is just a waste of money since the updated questions are not available….
hope digitaltut will solve this very soon.. not fair for us premiums.

@digitaltut, we are pleased to wait for the update. thanks!

Hello!
Does anyone know where to find huawei dumps?
Maybe there is a site like 9tut, but for huawei.
Thank you!

Dear fellow premies,
It takes a few weeks to verify, compile and format the questions. Digitaltut has done an amazing job thusfar in making sure that their premium information is top notch. We must all be patient and use this time to sharpen up on our knowledge with the already provided topics. I trust the update will come very soon and you should too. :)

to those who took the exam earlier can you verify these questions, have you encounter these?

1. A network administrator configured RSAN to troubleshoot an issue between switch1 and switch2. The switches are connected using interface Gigabitethernet1/1. An external packet capture device is connected to switch2 interface gigabitethernet1/2. Which two commands must be added to complete this configuration?

2. The connection between SW1 and SW2 is not operational. Which two actions resolve the issue?
3. Extended access-list 100 is configured on interface gigabitethernet 0/0 in an inbound direction, but it does not have the expected behavior of allowing only packets to or from 192.168.0.0/16. Which command set properly configures the access list?
4. An engineer must ensure that all traffic entering AS 200 from AS 100 chooses Link 2 as an entry point. Assume that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers. Which configuration accomplishes this task?
5. Which code results in the working python script displaying a list of network devices from the cisco DNA center?
6. What is the calculation that is used to measure the radiated power of a signal after it has gone through the radio, antenna cable, and antenna?
7. What does the number in an NTP stratum level represent?
8. An engineer must create a script that appends the output of the show process cpu sorted command to a file. Which action completes the configuration?
9. Which design principle should be followed in a cisco DS-access wireless network deployment? 10. An engineer is investigating why guest users are able to access other guest user devices when the users are connected to the customer guest WLAN. What action resolves this issue?
11. A customer has 20 stores located throughout a city. Each store has a single cisco access point managed by a central WLC. The customer wants to gather analytics for users in each store. Which technique supports these requirements?
12. Which OSPF network types are compatible and allow communication through the two peering devices?
13. How do cloud deployments differ from on-prem deployments?
14. The access points are failing to join the wireless LAN controller. Which action resolves the issue?
15. An engineer runs the sample code, and the terminal returns this output. Which change to the sample code corrects this issue?
16. When configuring WPA2 enterprise on a WLAN, WHICH ADDITIONAl security component configuration is required?
17. An engineer is configuring an etherchannel between switch1 and switch2 and notices the console message on switch2. Based on the output, which action resolves this issue?
18. What is a type 2 hypervisor? 19. What is YANG used for?
20. What is a characteristic of a WLC that is in master controller mode?
21. Which resource is able to be shared among virtual machines deployed on the same physical server?
22. Which function does a fabric access point perform in a cisco SD-Access deployment?
23. Which function is handled by vmanage in the cisco SD-WAN fabric?
24. Communication between London and new York is down. Which command set must be applied to the newyork switch to resolve the issue?
25. An engineer must configure a GRE tunnel interface in the default mode. The engineer has assigned an IPV4 address on the tunnel and sourced the tunnel from an Ethernet interface. Which additional configuration must be made on the tunnel interface?
26. A customer has a pair of cisco 5520 WLCS SET UP IN AN sso CLUSTER TO MANAGE ALL APS. Guest traffic is anchored to cisco 3504 WLC located in a DMZ. Which action is needed to ensure that the EoIP tunnel remains in an UP state in the event of failover on the SSO cluster?
27. In a cisco DNA center Plug and Play environment, why would a device be labeled unclaimed?
28. Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?
29. What is the effect of introducing the sampler feature into the flexible netflow configuration on the router?
30. Sw1(config)# vlan filter HOST-A-B vlan 10
31. Which outcome is achieved with this Python code?
32. An engineer must create an EEM applet that sends a syslog message in the event a change happens in the network due to trouble with ospf process. which action should the engineer use?
33. Which AP mode allows an engineer to scan configured channels for rogue access points?
34. Which outcome is achieved with this python code?
35. A network engineer must configure a password expiry mechanism on the gateway router for all local passwords to expire after 60 days. What is required to complete this task?
36. Drag and drop the descriptions from the left onto the routing protocol they describe on the right.
37. Which python code snipped prints the descriptions of disabled interfaces only?

Need correct Answers…

—this one was a comment from the other dump provider. He said this was the new questions he encountered. I just need verification and do research although I think those question need some images to support the questions.

Passed yesterday with 8xx – tough exam

There was over 30% new questions but managed to figure out 50% of these due to my knowledge and experience. The remainder questions were all from here and thanks go to digitaltut for a great site.

New questions in wifi, JSON, sd-wan, acl, DNA, chef and puppet to name a few. You need to master a few subjects so you can work out some the new questions and answer the remainder using digitaltut’s magic.

Another advise is due to new questions you need to manage your time as it’s going to take time to work new questions out. I only finished my exam with just 2 minutes to spare.

Good luck and thanks digital tut.

Hi @digitaltut hope update will come within this week, thanksmuch!

@TInker I had about 15 new questions from this list.
Still can pass with help of premuim.

@jO

Thanks bro for answering, Congrats also! Cheers

Hi Dweller,

to me both C and D will fix the issue.

C. channel-group 1 mode desirable > will force both interfaces to use PAgP
D. channel-group 1 mode active > will force both interfaces to use LACP

19 A type-2 hypervisor runs on top of a OS vmware fusion workstation and Hyper-v it does not run on baremetal like a type-1

Yang is used for data modelling so things are layed out in an easy to read format

33 WaP access mode sniffer

Q33:

Rogue Detection Modes (APs)

Local:
This is the normal operation of an AP. This mode allows data clients to be serviced while configured channels are scanned for noise and rogues. In this mode of operation, the AP goes off-channel for 50 ms and listens for rogues. It cycles through each channel, one at a time, for the period specified under the Auto RF configuration.

Monitor:
This is radio receive only mode and allows the AP to scan all configured channels every 12 seconds. Only de-authentication packets are sent in the air with an AP configured this way. A monitor mode AP can detect rogues, but it cannot connect to a suspicious rogue as a client in order to send the RLDP packets.

Note: DCA refers to non-overlapping channels that are configurable with the default modes.

Rogue Detector:
In this mode, the AP radio is turned off, and the AP listens to wired traffic only. The controller passes the APs configured as rogue detectors as well as lists of suspected rogue clients and AP MAC addresses. The rogue detector listens for ARP packets only, and can be connected to all broadcast domains through a trunk link if desired.

Can anyone share the latest dump Including the new questions?
Csam4320 at gmail

Hi all, I guess these are new questions. Can someone approve the answers?

1) A customer has 20 stores located throughout a city. Each store has a single Cisco AP managed by a central WLC. The customer wants to gather analytics for users in each store. Which technique supports these requirements?
A. angle of arrival
B. presence
C. hyperlocation
D. trilateration

2) A customer has a pair of Cisco 5520 WLCs set up in an SSO cluster to manage all APs. Guest traffic is anchored to a Cisco 3504 WLC located in a DM2. Which action is needed to ensure that the EolP tunnel remains in an UP state in the event of failover on the SSO cluster?
A. Use the mobility MAC when the mobility peer is configured
B. Use the same mobility domain on all WLCs
C. Enable default gateway reachability check
D. Configure back-to-back connectivity on the RP ports

3) Which resource is able to be shared among virtual machines deployed on the same physical server?
A. disk
B. operating system
C. VM configuration file
D. applications

4) Which function is handled by vManage in the Cisco SD-WAN fabric?
A. Establishes BFD sessions to test liveliness of links and nodes
B. Distributes policies that govern data forwarding
C. Performs remote software upgrades for WAN Edge. vSmart and vBond
D. Establishes IPsec tunnels with nodes.

5) How do cloud deployments differ from on-prem deployments?
A. Cloud deployments require longer implementation times than on-premises deployments
B. Cloud deployments are more customizable than on-premises deployments.
C. Cloud deployments require less frequent upgrades than on-premises deployments.
D. Cloud deployments have lower upfront costs than on-premises deployments.

Cloud deployments have lower up front costs as you only pay for what you use so i would say D is correct

Answer 3 is A disk as virtual disk is only a part of the physical disks vmware use vmdk and hyper-v use vhd virtual disks

Hello good luck

I passed in encor exam 30% in dumps only and 70% new questions

4) Which function is handled by vManage in the Cisco SD-WAN fabric?
A. Establishes BFD sessions to test liveliness of links and nodes
B. Distributes policies that govern data forwarding
C. Performs remote software upgrades for WAN Edge. vSmart and vBond
D. Establishes IPsec tunnels with nodes.

Answer should be C.
source: https://sdwan-docs.cisco.com/Product_Documentation/vManage_Help/Release_18.1/Maintenance/Software_Upgrade