Share your ENCOR Experience

Which action is the vSmart controller responsible for in an SD-WAN deployment?
A. onboard vEdge nodes into the SD-WAN fabric
B. distribute security information for tunnel establishment between vEdge routers
C. manage, maintain, and gather configuration and status for nodes within the SD-WAN fabric
D. gather telemetry data from vEdge routers

any help for the correct Answer

Waiting for confirmation if 121q + 44q is enough to pass ENCOR as of this writing. Thank you digitaltut community!

#NOTOABSCBNRENEWAL

Which action is the vSmart controller responsible for in an SD-WAN deployment?
A. onboard vEdge nodes into the SD-WAN fabric
B. distribute security information for tunnel establishment between vEdge routers
C. manage, maintain, and gather configuration and status for nodes within the SD-WAN fabric
D. gather telemetry data from vEdge routers

any help for the correct Answer.

^B

How many total questions are coming in exam??

slide 55

Use Cases
Internet Edge Firewall
Requirements
Connectivity and Availability
• High Availability ROUTED mode
• Firewall should support Router or Transparent Mode
Routing
• Static and BGP Routing
• Dynamic NAT/PAT and Static NAT
• Rate Limiting
Security & Identity
• Application Control + URL Acceptable Use
enforcement
• IPS and Malware protection
• SSL Decryption
VPN
• Site to Site and Remote Access

@ Zen
my be 102

Thanks @ABS-CBN

Which requirement for an Ansible managed node is true?
A. It must have an SSH server running.
B. It must be a Linux server or a Cisco device.
C. It must support ad hoc commands.
D. It must have an Ansible Tower installed.

any help for the correct Answer.

B. It must be a Linux server or a Cisco device.
we can use ansible with https request, so we dont need SSH server

Hi Guys,
for the following question the answer is A not B

A client devic,e roams between access points located on different floors in an atrium. The access points joined to the same controller and configuration in local mode. The access points are in different IP addresses, but the client VLAN in the group same. What type of roam occurs?
A. inter-controller
B. inter-subnet
C. intra-VLAN
D. intra-controller

^ answer is B — inter-subnet is same as L3 roaming. It changes the ip address given.

Inter-controller – this means that you will have the same ip address even if you have changed wlc

Best Answer for this? Some are A , in digitut is B

Which statement about LISP encapsulation in an EIGRP OTP implementation is true?
A. OTP uses LISP encapsulation for dynamic multipoint tunneling
B. OTP maintains the LISP control plane
C. OTP uses LISP encapsulation to obtain routes from neighbors
D. LISP learns the next hop

ABS-CBN

Guess you are right, answer should be A.

https://www.cisco.com/c/en/us/products/collateral/ios-nx-os-software/ip-routing/whitepaper_C11-730404.html

OTP leverages existing LISP encapsulation which:
• Allows dynamic multi-point tunneling

• Provides instance ID field to optionally support virtualization across WAN (see EVN WAN Extension section)

OTP does NOT use LISP control plane (map server/resolver, etc.) instead it uses EIGRP to exchange routes and provide the next-hop, which LISP encapsulation uses to reach remote prefixes.

Hi ,

Anyone took exam recently (today or yesterday) ?

Any new questions ?

@ Anmar – PS and ABS-CBN

thanks for the contribution.. I hope to take the exam by July 15 .. and I hope that at the beginning of the month 40 other new questions will not come out .. sigh ..

has anyone given exam recently, any new questions other than these files?

I just passed a few hours ago with a 944. The premium membership was enough to pass. There were only 2 questions that weren’t there. One was about vlans, the other about bpduguard. They were both CCNA level questions. If you can, I’d suggest taking this week.

I take it tomorrow….hope things go well…

^Good luck!

@GH

Thank you for your confirmation, almost 90% present on dumps?

To the community, wish me luck! Will have my Encor exam on July13.

Thanks!

@ ENCOR_Junkie

Hope U PASS. Good lucky

@ ENCOR_Junkie : All the best for the exam. Please try to remember the new questions (about bpdu-guard and vlan)

Which access control list allows only TCP traffic with a destination port range of 22-443,
excluding port 80?
A. deny tcp any any eq 80permit tcp any any gt 21 lt 444
B. permit tcp any any range 22 443deny tcp any any eq 80
C. permit tcp any any ne 80
D. deny tcp any any ne 80 permit tcp anyany range 22 443

Correct Answer: A or B ??

@ GH Congratulations

Is the 121Q and the new 44 Q enough to pass the encore exam ?

I just passed a few hours ago with a 909 score
number of Q : 103 q
most of the questions from two dumps : 44 from @Amer and 124 q dump
thanks for all brothers
many thanks @Amer and all brother shared any info to help us

i’m so sorry his name is : @Anmar
so many thanks @Anmar at 34 page number

this new 44 q from @Anmar

https://www . mediafire . com/file/270rd07yohtha0c/ccnp_ccie_350_401_new_26_jun_2020.pdf/file

also many q from 124 dump

@telecom
yes for sure i just passed, but please try to test before any change in this dump

good luck for all

@ ENCOR_Junkie
Oh, wow, break a leg! 😀

A client devic,e roams between access points located on different floors in an atrium. The access points joined to the same controller and configuration in local mode. The access points are in different IP addresses, but the client VLAN in the group same. What type of roam occurs?
A. inter-controller
B. inter-subnet
C. intra-VLAN
D. intra-controller

the answer D.

Mobility, or roaming, is a wireless LAN client’s ability to maintain its association seamlessly from one access point to another securely and with as little latency as possible. Three popular types of client roaming are:

Intra-Controller Roaming: Each controller supports same-controller client roaming across access points managed by the same controller. This roaming is transparent to the client as the session is sustained, and the client continues using the same DHCP-assigned or client-assigned IP address.

Inter-Controller Roaming: Multiple-controller deployments support client roaming across access points managed by controllers in the same mobility group and on the same subnet. This roaming is also transparent to the client because the session is sustained and a tunnel between controllers allows the client to continue using the same DHCP- or client-assigned IP address as long as the session remains active.

Inter-Subnet Roaming: Multiple-controller deployments support client roaming across access points managed by controllers in the same mobility group on different subnets. This roaming is transparent to the client because the session is sustained and a tunnel between the controllers allows the client to continue using the same DHCP-assigned or client-assigned IP address as long as the session remains active.

Reference: https*://*www.cisco.com*/c/en/us/td/docs/wireless/controller/7-*4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01100.html

I scheduled my exam for 16 July but I’m planning to take it before that day, because i saw some of you confirmed the dump became valid, I’m also premium member. any suggestions please?

Dear Ala’a, Anmar

Thanks for sharing the dumps again.
I will study the 44 q
Could you please let us know where we can find the 124q dumps

Many thanks and good luck everyone!

What are two reasons why broadcast radiation is caused in the virtual machine environment? (Choose two.)
A. vSwitch must interrupt the server CPU to process the broadcast packet.
B. The Layer 2 domain can be large in virtual machine environments.
C. Virtual machines communicate primarily through broadcast mode.
D. Communication between vSwitch and network switch is broadcast based.
E. Communication between vSwitch and network switch is multicast based.

in digital tut the anwsers are B and C in other dumps are A and D… help..

Which access point mode allows a supported AP to function like a WLAN client
would, associating and identifying client connectivity issues?
A. client mode
B. SE-connect mode
C. sensor mode
D. sniffer mode

When a wireless client roams between two different wireless controllers, a
network connectivity outage is experience for a period of time. Which
configuration issue would cause this problem?
A. Not all of the controllers in the mobility group are using the same mobility group name
B. Not all of the controllers within the mobility group are using the same virtual interface IP
address
C. All of the controllers within the mobility group are using the same virtual interface IP address
D. All of the controllers in the mobility group are using the same mobility group name

can someone share correct answers

So its confirmed that premium has been updated?

Pass.
Three new questions. One regarding what you measure with tx power, antena gain, etc, etc in number? asnwer are like , RSSI, dBi, Noise… Other about BPDU Guard and BPDU Filter.
Don’t remember the third.

Take the exam asap guys.

Which access point mode allows a supported AP to function like a WLAN client
would, associating and identifying client connectivity issues?
A. client mode
B. SE-connect mode
C. sensor mode
D. sniffer mode

ANS: D

When a wireless client roams between two different wireless controllers, a
network connectivity outage is experience for a period of time. Which
configuration issue would cause this problem?
A. Not all of the controllers in the mobility group are using the same mobility group name
B. Not all of the controllers within the mobility group are using the same virtual interface IP
address
C. All of the controllers within the mobility group are using the same virtual interface IP address
D. All of the controllers in the mobility group are using the same mobility group name

ANS B

Thanks Monek!

How many D&D ?

All D&D come from digitut. Lisp, Policing, EIGRP&OSPF

@Monek, did you take exam today? Please confirm i am taking in the next 4 hours

Don’t waste time, go ahead and take the test asap.

Don’t waste time, go ahead and take the test asap.

surely you shouldn’t waste time, but if the community continues to update you can go later. Why all this haste?

An engineer is describing QoS to a client. Which two facts apply to traffic policing? (Choose two)

A. Policing adapts to network congestion by queuing excess traffic
B. Policing should be performed as close to the destination as possible
C. Policing drops traffic that exceeds the defined rate
D. Policing typically delays the traffic, rather than drops it
E. Policing should be performed as close to the source as possible

C is correct, but is it configured close to source or destination? Help plz,

I also have to take the exam and thought of doing it for the middle of July. We hope well .

Hi guys

These were from the new Questions
1. the transmitted power, cable loss and antenna gain
Answer : to calculate the EIRP (Effective Isotropic Radiated Power).
2. Easy q for the bpduguard issue
3. Easy q for the trunk and vlans

Good luck for All.

Which statement about Cisco EAP-FAST is true?
A. It is an IETF standard.
B. It requires a client certificate
C. It does not require a RADIUS server certificate
D. It operates in transparent mode

Is correct answer A or C

Marvin, you’re right. If you aren’t feeling prepared, wait and study more.

An engineer is describing QoS to a client. Which two facts apply to traffic policing? (Choose two)

A. Policing adapts to network congestion by queuing excess traffic
B. Policing should be performed as close to the destination as possible
C. Policing drops traffic that exceeds the defined rate
D. Policing typically delays the traffic, rather than drops it
E. Policing should be performed as close to the source as possible

C is correct, but is it configured close to source or destination? Help plz,

C and E

Which statement about Cisco EAP-FAST is true?
A. It is an IETF standard.
B. It requires a client certificate
C. It does not require a RADIUS server certificate
D. It operates in transparent mode

Is correct answer A or C

C
C

I just passed the exam! All the questions here are valid. Thanks!