Share your ENCOR Experience

@Juancar
GRE Tunnelling in VRF Configuration Sim (Draft Version)

hi, should i learn the new questions or just focus on sections 4 from 11? thanks.

@digitaltut
what is the correct config for this sim BGP Neighbor Sim (Draft Version)
is it:

router bgp 400
bgp router-id loopback0

or

router bgp 400
bgp router-id 1.1.1.1

is it enough to pass the exam If I just study part 10 and 11 then 4 labs?

Anyone can share your exam experience?

I want to know if just studying last New ENCOR Questions will be enough for the exam or it is necessary to study all (including really old questions)?

@digitaltut please share updates dumps of ENCOR

Hi, how to open this file EVE-NG file? it is on UNL File format.

thank you.

Passed my exam today, got 94 Qs with 3 sims.
1.Archive Logging & NetFlow
2.GLBP Configuration
3.Port-Channel and Native VLAN
Exam is not difficult but you really need to understand the
technology so don’t go blind memorizing the questions
presented in this site. Some questions are the same
but also different formatted questions and new questions.
Very important to read carefully !!!!
Thanks again @digitaltut – Premium was well worth it.

Someone took the exam yesterday or maybe today?

I have my exam in some hours but i don’t know if it is enough to pass or there’s some new questions?

Hi, are there a lot of automation questions on the exam? (EMM, Puppet, Ansible, Python, etc..)

Thanks!!

@digitaltut should I learn the new questions or just focus on sections 4 from 11?

@suraj

your doubt is right because at the end they say try to ping the router id which is lo 0

but they actuall show pinging the advertised lo1 :D:D:D:D

and thats why it’s still the draft version

someone who attempted this in real exam can verify better what the question stated :)

did eve-ng file work for anyone in the labs section ?

Hi, I’m trying to do the HSRP sims but I cannot config the ” channel-group 1 mode active” it says invalid.

Is the config correct?

Hi, can anyone please share where to find the questions and answers? Thanks!

Passed today.I finished it in 90 min from 170 min (english non native).
There are was 4 new questions about SD-access(vSmart, interconnected sd-access between 2 sites and ACL)

@digital thanks
Premium was well worth it.

What does the laboratory “Logging and Netflow” consist of?

@Mah what all lab sims you got ? were there any questions from non-premium section as well ?

Passed today, 94 questions and 3 sims within.
1. HSRP sim
2. Portchannel and STP sim
3. netflow and archive log sim
it came a lot of wireless, network programing topics and 60% questions from here.
BGP, OSPF and EIGRP was piece of cake.If you feel week network automation and Wireless focus on them.

@Today, June 7th. passed freefile.no-izzzzzp.fr open link deduct zzzz

1.Archive Logging & NetFlow
2.GLBP Configuration
3.Port-Channel and Native VLAN
All qs same just few new

Able to confirm are the Sim same simulation as here?
For others, how can we verify if the answer is correct?

@Jim for me the SIMs
OSPF authentication with different area
OSPF without network statement
EEM

I recommended all to study from 1 to 11 parts.
@digitul the new question that I remember them
1- what are components for interconnect fabric SD access on or between two sites ( choose two)?
A- Interconnect fabric transit
B- VPN transit
C- IP-based transit
D- SD-Access transit
E- SAN transit

2- the role for vSmart in sd wan? I focus on 2 option that I remember them
A- ………..
B- Excute policies centerlized local.
C- ………
D- transaction information policies between OMP and routing … protocols.

3- D&D on- premises (with 2) and Cloud(with one)
Demand on self-service
Complexi customizability
about Hardware – related on-premises

4- there is a new question about NAT.

Yesterday I passed my exam wih passciscoexams.com

Visit now and clear your exam: https://www.passciscoexams.com/350-401-dump.html

Just passed exam, not snowing score only mentioned pass

@digitul the new question:
what are components for interconnect fabric SD access on or between two sites ( choose two)?
A- Interconnect fabric transit
B- VPN transit
C- IP-based transit
D- SD-Access transit
E- SAN transit

ANSWERS ARE C & D

What is a Transit ?
Multiple Fabric sites in a single Fabric domain will be interconnected using a Transit.

The SD-Access transit consists of Control plane nodes which helps interconnect multiple fabric sites.

There are two types of Transits:

SD-Access Transit – Enables a native SD-Access (LISP,VXLAN,CTS) fabric, with a domain-wide Control Plane node for inter-site communication.

IP- Based Transit – Leverages a traditional IP-based (VRF-LITE, MPLS) network, which requires remapping of VRFs and SGTs between sites.

IP Transit :

Traffic between sites will use control and data plane of the transit network/WAN.

The SD-Access Border will hand off the traffic to the directly connected WAN/External router and the traffic is delivered across the Wan/external domain to other site. No Lisp lookup with the transit control node is performed here as the border will hand off traffic to the WAN/External router using VRF-LITE.

If SD-WAN is deployed in the transit network/WAN then performance based routing, Encryption etc. in the WAN is possible.

End to end policy can only be maintained by Manual configuration.

Passed these days. Many thanks to the admins of this site.
All questions (except one or two), drag&drop, sims are listed in premium. (The test included questions not only from 4-11, but also from 1-3 parts – located in the relevant thematic sections on the right).
Simulations: BGP config, GLBP, Logging and Netflow.
Thanks again @digitaltut – Premium is worth it

Passed ENCOR today, premium was well worth it!

I’d say there were about 5 questions that that I hadn’t seen before, and they were mostly pretty similar to the ones found here. Recommend studying both the “new questions” sections in premium as well as all the named sections below them. The sims I got were all exactly like the ones listed here.

I had Sims: BGP Config (R1/R3 version), VRRP, and OSPF Config

My only recommendation is to make sure you’re not just doing rote memorization. If you absorb the info your reviewing, it can be actually useful!

Thanks again @digitaltut!

Passed today with an unknown score.

All questions valid with one or two worded a bit differently.

Had BGP (non-draft), GLBP and SPAN/Netflow sims.

Thanks as always Digitaltut, you are a life saver!

Did the exam today.
Just receive a email 2 hours after the exam with result Pass.
94 Questions
Labs:
EMM – Tip: after configuration put Lo0 manualy in shutdown to se if the EMM brings it up
BGP (as-override version)
OSPF Authentication
All questions from here!

Are in some site of the web the quiz from 1 to 3, like is part 4 to 11 in premium site?

Hi,

Why I cannot config OSPF. I tried it but it says

“Router process 1 is not running, please configure a router-id”

please help :(

Hi,

For Logging and NetFlow Sim, not working for me :(
What switch are you using if simulator is on GNS3?

When I type ———> ip route-p route-cache flow, router cannot detect it :(
% Invalid input detected at ‘^’ marker.

Pass today. 94 questions. Some new questions about automation. Labs – OSPF no network, BGP as-override, HSRP. Good luck and thx digitaltut for great job.

Passed. 94q, questions are valid. Labs GLBP, Port channel-Native Vlan, Logging and Netflow

Hello Everyone!

Just wanted to share that I passed the examination today. Total of 94 questions with 3 sims: HSRP, Port-Channel and Native VLAN, Logging and Netflow.

All questions here are valid. Premium purchase is indeed worth it. Don’t forget to study the questions on the left side tab(Questions Parts 1-3) as they are still being asked. Studied them on the very last minute and it saved me as there were a handful of questions from them.

Total study period was 2 weeks as I’m also busy with work and taking care of my baby. Wouldn’t advise you to have this short span of time to prepare! Take time to learn each questions, especially those you’re not familiar with.

Wish everyone here the best of luck!

Papuri sa Diyos sa kaitaasan!

passed, 94 questions, including 3labs (BGP as-override, GLBP, OSPF config)
in GLBP (group 30 and delay minimum 35), questions are valid.
thx @digitaltut !!!

Cleared today, got 94 questions including 3 labs [EEM, BGG (as-override), and OSPF Authentication]. I got OSPF auth lab but don’t need to configure MD5 authentication.

https://www.digitaltut.com/ospf-authentication-sim

thank you for suggestion i pass my exam with passcisoexams.com

passed.I got 94 questions, including 3labs (OSPF Authentication with Different Areas, VRRP, SPAN & NetFlow) questions are valid. Thanks for supporting @digitaltut..

Anyone aware why there are so many questions? We have the regular questions section and the new questions section. It seems like a lot to review.

@networkdad what do you mean by Don’t forget to study the questions on the left side tab(Questions Parts 1-3)

@Guitarist

This test has been active for 3 years now. Cisco adds questions every month. The question pool is now 800+ questions and 20 labs. It is alot to review. This is not an easy exam.

Hi….not able to see “questions on the left side tab(Questions Parts 1-3)”. Please can anyone confirm.

Passed, 94q 3x SIMS: Logging and Netflow, HSRP, Port-channel and Native VLAN. On the SIMs, like described in this site, we need to pay attention which task on which device you need to configure, also my DSW1 had wrong port config towards ASW1 which I had to remove … it might be the case I messed that up with interface range command). Questions match the ones here, but really you need to practice on all of them (sections + part 4 to part 11).

I will be renewing my CCNP, is ENSARI enough to renew my CCNP or I need to take the ENCOR?

@Sam

+ We removed New ENCOR Questions – Part 1 to Part 3 as they have been classified into specific topics under “ENCOR 350-401” category at the right-side menu (from “Architecture Questions” to “Drag Drop Questions 2”).

Hi @Confusion, can you send here your config on all the SIMs that you practice?
There are sims that I cannot configure. :(

I’m missing some of the config. huhu.
Really need it badly. I’ll be taking my exam on Aug Week 2.

@eric i also pass exam with your suggested website

sim is valid, but 20 percent of multipple questions match