Share your ENCOR Experience

thanks! @CCNP-2022

Passed. Finaly. One of the longest exams I took from Cisco.
All content here still valid to pass exam.
Got sims:
IpSla, Span, Top Talker – same as here
Vrrp – same as here
Ospf – 3 routers (areas 1-0-2)with network commands and wildcard mask(eth+lo)
Md5 on eth, router id, process id

Studied from December, passed big compozit here many many times on 97%
5-7 new questions.
Two new drag&drops with Python scripts
I recall one Q with TrustSec and what is “weight” used for.
One with Access list to allow only one subnet from two behind the router to communicate with outside world.
Good luck.

Is spoto dumb reliable?

You want reliability? Pay for it here, get it here. Enough said.

Passed Yesterday.

Labs:

BGP ( exact same R1 and R3 configuration)
GLBP ( exact same) dont confuse with access switch.
Monitoring sim ( SWITCH 1 IP SLA configuration , R1 configure it with TOP Talkers )

10- 15 new questions.
i remember one.

event manager applet noconfig

event cli pattern “configure terminal”

action 2.0 cli command “enable”

options were:

sync no skip yes
sync no skip no
sync yes skip yes
sync no skip no

correct answer is sync no skip yes

( make sure go through 4-10 premium questions and old ENCOR 350-401)

I’m taking the exam next week..But I’m afraid the dump will change
Is anyone taking it next week?

Hello, Please put the new questions here, I read several comments about 10-15 new questions

Please post new questions…My exam is tomorrow

I studied ENCOR by myself and took some training in a center. Plus, I have spoto dumb from 16/1/2023
My exam is tomorrow will I pass? or should I postpone it until new questions appear? I studied some of the questions here as they are like the spoto ones.
I’m actually afraid I will fail…400 USD is too much

@Anonym (who posted on Feb 10)

I took mine on Feb 10. Looks like you and I had the same test.
3 Sims: BGP, GLBP and Monitoring Sim

Def 10-15 Questions I didnt recognize but was able to decipher.

I remember seeing the “sync no skip yes” question.
——————————–
I unfortunately did not pass. My job is willing to pay for 2 vouchers. So I took this first test just to see how well I am and how the test set up is.

Overall digitaltut is absolutely worth the money. I just need to put in more time and complete some more practice test.

Retesting in a week. Sure I’ll do fine.

Hi guys
I wanted to share with you that I just passed my exam and didn’t want to bow out without giving you some recommendations.

The DIGITAL TUT balotaries are good but if you want to make sure you pass the exam, you must understand each topic as you will always find at least 15 new questions.
Among the 15 questions, I got some new ones about EEM, TACACS, MAC Access Control Lists, WLC, a new question about the difference between OSPF and EIGRP (you must know the difference between Multicast Address of each protocol).
From the LAB I got OSPF to establish adjacencies without the network command (very easy), EEM (identical to the one here) and BGP but with the difference that you do not apply the allowas-in command if you do not have to apply the as-override command.

Don’t give up, the exam is passable.

Why did you fail if you studied here at tut? @ASDFJKL

Passed today. All practice questions here are valid, same goes for the labs.
Good luck Guys

@Kazem

Congrats. How many new questions did you get that are not there in the practice questions?

Thank you bro….I think 5-6 questions, SD-Fabric and automation but they are easy
I practiced all of the exam questions here

Today I passed.
About 10 questions I’ve never seen.
One of them I remember is about “LISP weight” question.
OSPF Sim and Monitoring Services Sim are not exactly as on digitaltut, so please be careful.
I’ll post detail on each page.

How many questions are available in the DigitalTut Premium Membership?

@ K4I,
We await your detail’s, it will help…

@Panger_Lenis a lot

God Day All, Wrote the Exam last week on the 9th, my results were pending.
Received the Result that I passed a day later.

The content on Digitaltut as confirmed by others above is still valid with 5 or so new questions. Please note that due to the Labs/ Sims which I had 3 (Monitoring, EEM & OSPF) you need to work thru the questions quickly. Do not waste time. It is a long paper which makes Time your Enemy.

@Anonymous

You asked why I failed if I studied here at tut.

Answer:
My job is willing to pay for two vouchers. So at the time of testing I was prob only half way through the digital tut material. I was scoring between 65-75% on the big composite quizzes. Def not where I needed to be.

I had not gotten to some of the SIMs digitattut offers (all 3 sims on the test are here on tut) and wasnt able to complete 2 out of the 3 I saw. <- Completely my fault.

If you follow the instructions of TUT. As in go through all the questions, pass the composite quizzes and in addition lab out all the SIMs you should be fine.

Now I know where I stand and will be putting in the work for the remainder of the material.

I passed my exam today!
My comments are the same as @PassedToday
Thanks @Digitaltut!

Hello,

If we giving the exam at a Test center, do we get the test result(Pass/Fail) immediately after we complete the exam or do we have to wait for the result?

Question to all: Which book do you study from?

@SM

at test center in the end of your exam you will see your test result immediately .

@SM

@arkoolik is correct. You will see your result immediately.

However…… when I took my test the other day it said “Pending”!!
Everyone I asked had never seen it.
After googling it, everything said wait a few and then recheck on the pearson vue website.
Think 3 hours later it finally populated.

But normally will see immediately.

@digitaltut

some users got OSPF lab, where they required to use “network” and “subnetmask” statement on “all interfaces”.

Kindly update config with new config asap.

@digitaltut

some users got BGP lab, where they required to use “allowas-in” or “as-override” statements..

Kindly update all information provided by users.

@ arkoolik

Thanks for the clarification.

@Cheetah

@Anônimo

The updates are under the BGP Configuration Sim notes

@CCNP-2022

I am asking about the OSPF lab, where they are required to use “network” and “subnetmask” statement on “all interfaces” instead of ” without using the “network” statement “

@digitaltut Please post the updated OSPF lab which requires the use of “network” and “subnet mask”. I am going to take the exam in two days.

@ASDFJKL: the same thing happened with me as well. It was “Pending” for 2 days.
Finally, I passed. So if someone sees it, just be patient.

Guys, Which book do you study from?

@Asfix, CCNP Enterprise Core ENCOR 350-401 and Advanced Routing ENARSI 300-410 Official Cert Guide Library By Kevin Wallace + CBT Nuggets

@Sandhya

The pool of questions is only available in premium

Hi All.
Passed today. Some new questions about SD-Access and other, about 5 or 10.
OSPF lab was with requirement to use key 1, network statements. EEM like on this site.
So something like this
>>
key chain 1
key 1
Cisco(password in clear text)
>>
totally 98 questions, 3 sim (ospf, ospf auth, eem)
Thank you digitaltut!

Passed encore today. Lab on port channel, HSRP and netflow. Will post details in the lab links.
About 10 new questions. One was about which queuing method provides strict priority queue. Answer is Low latency queuing. Another question was difference between CEF and process switching. I forgot the answer selections but it was something in relation to the type of physical CPU used and where it is stored in memory.

Yea same as everyone who has taken the exam lately. Had three sims and new questions. I had ((BGP(different commands),OSPF(Same commands), and vrrp (almost same but no authentication needed just advertise) labs)) If you go through the questions and actually learn why the answers are what they are you’ll be fine. Thanks Tut!

I did my exam today, my marks didn’t populate but said pass.

Saw about about 5 new questions python drag and drop. Had too many drag and drop questions
Lab bgp (can only access R2 so as-override command), ospf without network command and vrrp with delay 35. If you practice all the questions here you’ll pass. Good luck everyone

@digitaltut,

when will we get the updates?

Many people says that there is new drag and drop for Python. Do someone remered it to share with us?

Just passed.
Less or more 10 new questions (It is ok if u know concepts. They are just in different forms but I have never seen 3 or 4 questions so i guessed and chose.)

Port-Channel and Native VLAN
{Same as her just different port no}

GLBP
{same as here just different min delay 35}

Monitoring Services Sim
{Not all described here. Just archive without logging size and R(config if)# ip flow ingress} top-talker is already configured.

Got average 96%

Thanks a lot to everyone who commented here and of course digitaltut & networktut.
Finally CCNP

Hi
Can anyone please help me to provide the dumbs to study CCPN ENCOR?
I Could not find anywhere..
Many Thanks.
Sam

@Sam, this is a website from the purpose.

Do you know if the questions only come from sections 4-10?

Finally passed the ENCOR. Thank you Digitaltut for the practice questions and sims.
Had a few new/reworded questions.
3 SIMS IP SLA/Flow/SPAN
OSPF
GLBP
Studied for pass few months. kept taking short practice test.

@ENCOR_2023
Is same sim what is in this website or different?

@ENCOR_2023,
Congratulations First of all..
Can you please share, is there any lab or sim in the question that we need to enter the commands, save and test the successful connectivity or there is lab or sim question where we enter the commands to find the output and select the answer from A,B,C or D choice?
It will be big help..
Thanks..

Hello Guys,

Finally passed the ENCOR after two months of studying. The exam format details I got are:

– Total 98 questions
– Many drag and drops questions
– 3 labs
(OSPF without using the “network” statement)
(GLBP with preemption delay for AVG)
(BGP allow communication between two connected remote sites by config only middle router)

Please study the concepts and follow @digitaltut recommendation to study the premium topics and you will be able to pass

Thanks a lot @digitaltut your support, and good luck to all of you guys. :)